Flipper Zero V2 ESP32 and NRF24L01 Wifi Dev Board With Antenna in

(115)

Écrire un avis

Plus

€ 49.50

Ajouter au panier

quantité

En Stock

Description

*Flipper Zero is not included This listing has been updated for V2 of the ESP32 and NRF24L01 module. ESP32-WROOM-32 and NRF24L01 modules inside a 3D Printed case. The Flipper Zero is not included. V1 and V2 are the same in terms of function, but V2 has a smaller footprint. All V2 orders also come
*Flipper Zero is not included This listing has been updated for V2 of the ESP32 and NRF24L01 module. ESP32-WROOM-32 and NRF24L01 modules inside a 3D Printed case. The Flipper Zero is not included. V1 and V2 are the same in terms of function, but V2 has a smaller footprint. All V2 orders also come with a 3D Printed pin protector. BOOT and RESET buttons have been shortened to "B" for BOOT and "R" for RESET. A 3.3v regulator is connected to Flipper Zero's 5v GPIO to maintain a steady voltage to the modules. You have to enable 5v on GPIO in your Flipper Zero. The power switch lets you choose between the ESP32 and NRF24L01, they cannot both be powered at the same time. Switch the power to the module you want to use and enable 5v on GPIO before opening an application. The ESP-WROOM-32 comes pre-flashed with Marauder and the 3D printed case gives you access to the USB port and BOOT and RESET buttons on the ESP32. The NRF24L01 has an external antenna that can be removed for easier storage. The antenna is not shared between the modules. The ESP32 is also able to run Evil Portal (Needs to be flashed) These are made to order so please allow up to 5 days after you place your order for your order to ship. If you have any questions, leave me a message. *This tool is for educational and research purposes only. The user is responsible for understanding and complying with all applicable laws and regulations.